Made of strong, corrosion-resistant PVC. Caps fit atop standard PVC duct, permits vertical discharge of effluent air above roofline for dispersion away from the building. Caps add little static pressure to the exhaust system.

PVC exhaust duct is Type I, unplasticized, schedule 40, lightweight and corrosion-resistant. A Female Duct Coupling is required to join two sections.

Epoxy-coated Steel Blower Transition Adaptors allow you to connect thermoplastic duct to the exhaust side of a blower to create an exhaust stack. Nominal size PVC duct fits inside the adaptor opening.

PVC fitting compatible with thermoplastic duct. End connections receive PVC pipe directly. 0516E96 - PVC "T" Connection: Duct Diameter: 10" Duct Diameter: 12" Duct Connection Diameters: 10" x 10" x 12" Height: 19" Equivalent Resistance in feet of Straight Duct: 20' …

10' length of 2" diameter steel-reinforced vinyl duct with 2 clamps.

Reduce vibration between the blower and PVC ductwork. Include two clamps for easy installation.

PVC coupling type reducer designed for connecting thermoplastic duct of different diameters with no equivalent resistance.

Corrosion-resistant, neoprene-impregnated fiberglass reinforced with steel wire. Include rigid duct connector and two clamps. Because this ductwork is flexible and may conform to various configurations, it is not possible to know the precise equivalent resistance.

5165H59: Powder-coated steel Exhaust Damper, 6" diameter, in-line, adjustable. Allows for airflow adjustment to maintain proper airflow for remote blower or house exhaust systems. 1' equivalent resistance. 5165J25, 0516E55, 0516E98, 0516E97 & 0516G13: PVC Manual Duct Dampers allows you to…

45º PVC Elbows. Compatible with thermoplastic duct. Designed and engineered for quick installation and minimum pressure loss. Feature belled end connections to receive PVC duct directly.

90º PVC Elbows feature belled end connections to receive Thermoplastic Duct or Male Duct Coupling directly. Designed and engineered for quick installation and minimum pressure loss.

Lower Exhaust Transition Adapters are epoxy-coated steel, 2" x 10" rectangular to 5" or 6" diameter round for connection to 5" or 6" ID hose. Allows for connection of hose to the bottom of the rear plenum of the XPert Balance Enclosure, Protector XVS Ventilation Station, Protector Work Station or…

Wash Ring, wide angle conical spray nozzle, and wash water connection nipple are fabricated into a PVC coupling. For Stainless Steel or PVC Perchloric Acid Hoods. 10" Diameter Flow rate is one gallon per minute at 40 psi. 12" Diameter Flow rate is 0.70 gallons per minute at 20 psi.

PVC Duct Coupling connect two sections of Thermoplastic Duct.

42" length of 2" diameter steel-reinforced vinyl duct with two clamps.