TLC Plates
-
-
Silica Gel G UNIPLATES
Miles Scientific (Analtech)Silica Gel G & GF UNIPLATES are the most widely used silica gel TLC plates. No organic substances are added to these products, thus making them compatible with sulfuric acid charring visualization.These plates are commonly scraped from the glass backing to isolate separated components for other…
-
Baker-Flex'® Silica Gel Ib2-F 1 Pk
Avantor - J.T.Baker®Flexible TLC Sheet for laboratory, research or manufacturing use Baker-flex™ polyester-backed sheets can be easily cut to remove a section of the sheet when you need to isolate a sample component of particular interest. Sheet Size: 2.5 x 7.5 cm Sheets/Package: 200 …
-
Rectangular Developing Tank
General Glass BlowingBeveled inside and outside to remove any sharp edges Raised ridge midway on the inside ends and bottom for developing two 20 x 20 cm plates or the equivalent Inside dimensions: 27 x 7 x 26 cm Supplied with flat glass lid, 30 x 10 x 3 cm Molded glass block of clear glass with…
-
TLC Silica Gel 60 F254 with Concentrating Zone 20 x 2.5 cm
MilliporeSigmaThese plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Millipore concentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied;…
-
Nano-SIL Unmodified HPTLC Silica Layers
MACHEREY-NAGELFeatures Nano silica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 µm Indicator: manganese activated zinc silicate with green fluorescence for short-wave UV (254 nm) Binder: highly polymeric product,…
-
Silica Gel GHLF UNIPLATES
Miles Scientific (Analtech)These plates are 100% H20 resistant and are compatible with aqueous developing solvents. They are less rugged than the plates with organic binder but still provide improved handling and sample application compared to Silica Gel G UNIPLATES and are tough enough to write on with a soft pencil, if…
-
TLC SILICA GEL 60 W F254S 25 GLASS PLATES 20 X 20 CM
MilliporeSigmaEMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
-
TLC Reagent Sprayers
DWK Life Sciences (Kimble)Provides a uniform spray mist of visualization reagents for both thin layer and paper chromatography Borosilicate glass Handles all standard TLC spray reagents and most corrosive liquids Creates consistent spray patterns that are free of damaging droplets The connection between the sprayer…
-
TLC Silica Gel 60 F254 GLP
MilliporeSigmaThese plates feature individual laser coding for GLP applications. Designed for GLP applications, the tops of each of these plates bear an item, batch, and individual plate number. As a result, lab professionals can easily record and archive every plate they use. Based on proven EMD Millipore…
-
Fibrous cellulose impregnated with polyethyleneimine available as POLYGRAM® polyester sheets with or without fluorescent indicator Recommended application: analysis of nucleic acids, and of mutagenic substances with the 32P postlabelling procedure
-
Glass TLC Plates
MilliporeSigmaFor thin layer and preparative layer chromatography Ready-to-use Layer thickness 0.25 mm Allow safe spotting without layer damage Plates have a uniform, abrasion-resistant coating and a patented, inert, hard-layer binder that is chip and abrasion-resistant. F254 is a…
-
Designed for in vitro diagnostic assays. Flat bottom strips are designed to easily break apart and may be used in an "egg-crate" style strip holder that allows each individual well to be positioned back into the plate once broken. High binding surface binds medium (>10kD) and large biomolecules…
-
These plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Milliporeconcentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied; the…
-
TLC SILICA GEL 60 RP-8 F254S 25 GLASS PLATES 5 X 10 CM
MilliporeSigmaRP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
-
Thin-layer chromatography (TLC) plates for adsorption, partition, and ion-exchange techniques. Six media choices with glass, polyester, and aluminum backings. Silica-based adsorbent layers in Sigma-Aldrich TLC plates incorporate a polymeric binder; highly purified silica gel plates incorporate a…
-
Cellulose MN 300 Native Fibrous Cellulose Layers for TLC
MACHEREY-NAGELFeatures Fiber length (95 %) 2–20 μm, average degree of polymerization 400–500 specific surface acc. to Blaine 15000 cm 2 /g ≤ 20 ppm Fe, 6 ppm Cu, 7 ppm P; dichloromethane extract ≤ 0.25% residue on ignition at 850°C ≤ 1500 ppm available as glass…
-
Thomas Glass Sprayer
labForce® (powered by Thomas Scientific)Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…
-
HPTLC Silica Gel 60 F254
MilliporeSigmaHPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
-
Alox Aluminium Oxide Layers for TLC
MACHEREY-NAGELAluminium oxide, specific surface (BET) ~ 200 m 2 /g, mean pore size 60 Å; inert organic binder indicator manganese-activated zinc silicate available as glass plates, POLYGRAM® polyester sheets and ALUGRAM® aluminium sheets Recommended application: terpenes, alkaloids,…
-
TLC Silica gel 60
MilliporeSigmaClassic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.
-
Labels applied to all 4 sides of the plate. No sequence number duplicates. Exceptional print quality and resolution. Resistant to commonly used laboratory reagents. Resistant to temperature ranges of -80ºC to +52ºC. See Product Details below for bar code label specifications. Microplate…
-
HPTLC Silica gel 60 F254
MilliporeSigmaPlates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother surface…
-
TLC Silica Gel 60 F254 Multiformat Pre-scored to 5 x 20 cm
MilliporeSigmaThese pre-scored glass plates fold into smaller formats with just one easy snap of the fingers. HS Code: 3822 00 00
-
CHIRALPLATE Special Layer for TLC Enantiomer Separation
MACHEREY-NAGELFeatures Reversed phase nano silica impregnated with Cu(II) ions and a chiral selector (a proline derivative, DP 31 43 726 and EP 0 143 147) Separation based on ligand exchange, i. e. formation of ternary mixed-ligand complexes with the Cu(II) ions differences in the stability of the…
-
Baker-flex® Coated TLC Aluminum Oxide Sheets
Avantor - J.T.Baker®Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
-
Features IONEX-25 SA-Na: mixture of silica and a strongly acidic cation exchanger coated to polyester sheets IONEX-25 SB-AC: mixture of silica and a strongly basic anion exchanger coated to polyester sheets Both layers contain an inert organic binder. Recommended application:…
-
Glass-Backed Analytical TLC Plates
Miles Scientific (Analtech)This TLC plate can be developed using purely organic, organic/aqueous, and purely aqueous mobile phases. Due to this these plates have been used in numerous applications in normal phase chromatography as well as reversed phase chromatography. Common applications include the analysis of active plant…
-
Baker-flex® Coated TLC Silica Gel Sheets
Avantor - J.T.Baker®Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
-
Nano-SIL C18 Octadecyl-Modified HPTLC Silica Layers
MACHEREY-NAGELFeatures Base material: Nano-silica 60, specific surface (BET) ~ 500 m2/g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 μm, pH stability 2–10 Partial (50%) or complete (100%) octadecyl modification, carbon content 7.5 and 14%, respectively…
-
These plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Millipore concentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied;…
-
TLC LuxPlate® Silica gel 60 F254
MilliporeSigmaClassic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.