Automatic Siphon Pipet Washer-Rinser
- Constructed of high-density polyethylene
- Plastic resists corrosive action of common cleaning solutions, reduces scratching and breakage of glassware
Chambers and carriers are offered in two sizes for pipets, burets, etc., up to 400 mm and 600 mm long. Either carrier holds approximately 175 standard 1 mL pipets (7 mm o.d.). Operates with water input from 1 1/2 to 12 liters per minute.
Siphoning cycle of smaller size is completed in approximately 70 to 90 seconds, with properly adjusted water pressure and requires approximately 3 3/4 gallons (10 liters) of water for each cycle. At same water pressure, the larger size has cycle of 100 to 200 seconds, requiring 4 1/2 gallons (17 liters) of water for each cycle. Cycles are repeated as long as water supply is connected. Washing chamber and pipet carrier must be purchased separately.
7792H54 and 7792H64
- One-piece, molded chambers, 152 mm i.d. x 260 mm wide
- Inlet connector is near base for stability; water enters chamber at top to prevent back flow
Furnished with 1.2 and 0.5 m length of PVC tubing for connection to source and drain. 7792H54 Chamber, for pipets up to 400 mm, has overall height of 772 mm. 7792H64 Chamber takes pipets up to 600 mm and is 965 mm high.
7792H78 and 7792H88
- Fits washing chambers of corresponding size
- Both baskets are 127 mm i.d, with a maximum o.d. below handle of 140 mm
- Perforated bottom plate is recessed 19 mm for complete drainage
Baskets also fit polyethylene jars 6204D28 and D34 respectively, for soaking and rinsing of pipets. 7792H78 carrier, for 400 mm pipets, is 445 mm high to the handle; depth 356 mm. 7792H88 carrier, for 600 mm pipets, 648 mm high to the handle; depth 533 mm.