Because Empty Shelves Are Sad Shelves
Select up to 3 products
Hickman Still Head, with Side Port, Synthware, Joint: 14/10, for microscale fractional distillation, supplied with one compression cap, one Viton O-ring and one PTFE-faced silicone septum.
Column length is measured from the highest to lowest indent in the column.
Trap is placed between the vapor tube and the evaporation flask. This design prevent possible contamination in the event of bumping. With upper outer and lower inner standard taper joints.
Synthware rotary evporator anti-splash trap, modified. With extra coarse porosity fritted disc sealed above lower inner joint. Trap is placed between the vapor tube and the evaporation flask. This design prevent possible contamination in the event of bumping. Frit reduces foam overflow from being...
Ideal for use as a vent or for the introduction of pressure/vacuum Glass male Standard Taper joint with hose barb for tubing at 90° angle Thomas numbers 5737A01 and A03 take 1/4” tube fitting; others are 3/8”.
Synthware combination adapting connector with a top spherical socket joint and a lower standard taper inner joint.
Trap is placed between the vapor tube and the evaporation flask. This design prevent possible contamination in the event of bumping. With two 4mm drain holes at the base of the inner tube to allow solvent to drain back into the evaporation flask. Has upper outer and lower inner standard taper...
Allows interfacing of inner Standard Taper jointed glassware with threaded microscale components Manufactured from 33 expansion, low extractable borosilicate glass conforming to USP Type I and ASTM E438, Type I, Class A requirements
Allows for flexible tubing to be connected to apparatus for introduction of vacuum or pressure.
Synthware reducing adapters are used for connecting dissimilar standard taper joint sizes. The lower inner joint is larger in size than the top outer joint.
Ace Glass pressure tubes and bottles are the premier glass pressure vessels in the industry. Flat-bottomed bottles are rated at 60psi at room temperature while our tubes are rated at 150psi at as much as 120 degrees C. Due to varying conditions, Ace ca
For standard taper joints Knurled gripping-ring at top, which allows quick, simple removal from joint Easily cleaned For use with full or medium joints Three gaskets per package. Joint size given in listings below.
Pyrex Standard Taper Connecting Tubes (5738E14) Arms are approximately 75° apart Equipped with inner Standard Taper joints that are both 24/40 Often used as a still head adapter Still Head Standard Taper Connecting Tubes (5738H82 and L18) Sidearm is at an angle approximately 75° from the...
Glass viewing tubes contain 5 mL mark.
Synthware distillation connecting adapter. With standard taper top outer joint and inner joints at bottom and the side arm. Bottom and side arm joints are angled at 75 degrees to one another.
For use with gas inlet tubes or plain stem thermometers. Supplied with one holed rubber adapter.
©Supply My Lab 2018 All Rights Reserved.
Terms & Conditions
In a hurry? You can check out as a guest!
Don't have an Account?
Create one now.