TLC Plates
-
Cellulose plates (TLC and HPTLC)
MilliporeSigmaFor analysis of polar substances The organic sorbent cellulose is particularly suitable for the separation of hydrophilic substances by partition chromatography. EMD Millipore cellulose plates include classical TLC grade or HPTLC plates for demanding high-performance separations: TLC…
-
Silica Gel HLF UNIPLATES
Miles Scientific (Analtech)These are the most rugged silica gel plates available. They not only ease handling and sample application, but also permit the use of up to 80% water in the developing solvent without loss of adherence of the adsorbent layer to the glass plate. Organic binder plates are recommended for all TLC…
-
Glass-Backed Analytical TLC Plates
Miles Scientific (Analtech)This TLC plate can be developed using purely organic, organic/aqueous, and purely aqueous mobile phases. Due to this these plates have been used in numerous applications in normal phase chromatography as well as reversed phase chromatography. Common applications include the analysis of active plant…
-
-
10 cm Latch-Lid Chromatotank
General Glass BlowingRequires less solvent to maintain equilibrium Gives excellent retention of solvent saturated chamber Holds two 10 x 10 cm plates The smaller cubic inch chamber allows for a faster and more uniform solvent-saturated atmosphere. Single molded tank has a flat ground top, beveled for…
-
SIL G Unmodified Standard Silica Layers for TLC
MACHEREY-NAGELSilica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Thickness of layer for analytical plates 0.25 mm, for preparative plates 0.5 and 1 mm For 2 mm preparative layers a slightly coarser…
-
Baker-flex® Coated TLC Silica Gel Sheets
Avantor - J.T.Baker®Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
-
These plates allow users to quickly and easily apply any kind of sample, even large volumes of diluted samples. EMD Milliporeconcentrating zone plates are based on different adsorption properties of two adsorbents. The first is a large pore concentrating adsorbent where the samples are applied; the…
-
TLC Silica Gel 60 F254 Multiformat Pre-scored to 5 x 20 cm
MilliporeSigmaThese pre-scored glass plates fold into smaller formats with just one easy snap of the fingers. HS Code: 3822 00 00
-
TLC LuxPlate® Silica gel 60 F254
MilliporeSigmaClassic silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to damage the layer.
-
Baker-Flex'® Silica Gel Ib2-F 1 Pk
Avantor - J.T.Baker®Flexible TLC Sheet for laboratory, research or manufacturing use Baker-flex™ polyester-backed sheets can be easily cut to remove a section of the sheet when you need to isolate a sample component of particular interest. Sheet Size: 2.5 x 7.5 cm Sheets/Package: 200 …
-
TLC SILICA GEL 60 W F254S 25 GLASS PLATES 20 X 20 CM
MilliporeSigmaEMD Millipore classical silica TLC plates are based on a combination of proven EMD Millipore silica gel 60 and the addition of a unique polymeric binder resulting in a very adherent and hard surface that will not crack or blister and even allow writing with a pensil on the surface without risk to…
-
HPTLC Silica gel 60 F254
MilliporeSigmaPlates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother surface…
-
HPTLC SILICA GEL 60 NH2F254S 25 GLASS PLATES 10 X 10 CM
MilliporeSigmaOur NH2, CN and DIOL -modified silica sorbents are less polar then conventional silica phases, making them ideal for separating hydrophilic or charged substances. Our moderately polar cyano- and diol-modified silica plates can be used for both normal phase and reversed phase systems. An alternative…
-
Silica Gel F TLC Plates
Miles Scientific (Analtech)Analtech’s flexible backed TLC plates offer the same exacting specifications as with the classic glass backed plates assuring batch-to-batch uniformity. Quality is controlled at each step in the manufacturing process — from incoming raw materials to outgoing packaging. Lighter…
-
Thomas Glass Sprayer
labForce® (powered by Thomas Scientific)Provides uniformly fine mist or spray, required for paper chromatographic determination Conveniently located vent permits instantaneous control of spray Borosilicate glass tube has permanently attached, molded phenolic screw cap (size No. 24) with polyvinyl liner which fits commercial narrow…
-
HPTLC silica gel 60
MilliporeSigmaHPTLC plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
-
Nano-SIL C18 Octadecyl-Modified HPTLC Silica Layers
MACHEREY-NAGELFeatures Base material: Nano-silica 60, specific surface (BET) ~ 500 m2/g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 μm, pH stability 2–10 Partial (50%) or complete (100%) octadecyl modification, carbon content 7.5 and 14%, respectively…
-
Synonyms: TLC cards Silica gel
-
TLC Plate Storage Rack
General Glass BlowingStore TLC plates without damaging delicate media Holds up to 10, 20 x 20 cm plates or equivalent number of narrower plates Racked plates may be air or oven dried Can be used with plates in either vertical or horizontal position Racks are also used for storage of dried layers…
-
Sigma-Aldrich® TLC Plates silica gel matrix
MilliporeSigmamaterial polyester support, silica gel matrix feature binder Polymeric, fluorescent indicator L × W 20 cm × 20 cm layer thickness 200 μm particle size…
-
TLC Cellulose
MilliporeSigmaThese cellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…
-
HPTLC CELLULOSE F 50 GLASS PLATES 20 X 10 CM
MilliporeSigmaCellulose plates are used to analyze polar substances. An organic sorbent, cellulose is perfect for separating hydrophilic substances by partition chromatography. Typical applications include the analysis of amino acids, carbohydrates, and phosphates as well as nucleic acid and nucleic acid…
-
Features Silica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 5–17 µm; standard grade Outstanding wettability for precise colorization results, even with 100 % aqueous detection reagents Excellent separation…
-
HPTLC Silica Gel 60
MilliporeSigmaThese plates deliver fast and quantitative analysis of complex samples for manual or automated use. EMD Millipore’s HPTLC silica plates work three times faster than conventional TLC plates – and they’re more sensitive. The particle sizes range in HPTLC is between 4-8µm, which creates a smoother…
-
Baker-flex® Coated TLC Aluminum Oxide Sheets
Avantor - J.T.Baker®Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
-
Baker-flex® Coated TLC Cellulose Sheets
Avantor - J.T.Baker®Ready-to-use plastic sheets, 50 x 200 mm or 200 x 200 mm, with absorbent coating, which is abrasion-resistant and highly uniform; are easily cut to desired size and allow sample fraction to be cut rather than scraped The silica gel and aluminum oxide sheets have coating approximately 200 microns…
-
Latch-Lid Chromatotank Unit
General Glass BlowingClear glass sides allow unobstructed visual inspection of contents Tank is ground flat to match ground glass lid. Beveled inside and outside to remove any sharp edges. Holds two 20 x 20 cm plates or four 10 x 20 cm plates. Latching device holds the matching ground glass surfaces of the lid…
-
TLC Silica Gel 60 RP-18 F254s
MilliporeSigmaRP modified plates serve two purposes: act as a pilot method for HPLC and allow to choose various solvent system for special separations. RP-modified silica layers from EMD Millipore are well suited for many separation challenges that unmodified silica cannot overcome. These layers use aqueous…
-
Nano-SIL Unmodified HPTLC Silica Layers
MACHEREY-NAGELFeatures Nano silica 60, specific surface (BET) ~ 500 m 2 /g, mean pore size 60 Å, specific pore volume 0.75 mL/g, particle size 2–10 µm Indicator: manganese activated zinc silicate with green fluorescence for short-wave UV (254 nm) Binder: highly polymeric product,…
-
-
ProteoChrom® HPTLC Cellulose Plate
MilliporeSigmaWe’ve enhanced our ProteoChrom® plates to make separation highly efficient – especially when peptides and protein digests need to be analyzed. ProteoChrom® plates take performance to new levels. Applications are highly reproducible thanks to optimized separation and staining procedures. With…